top of page

How to Stop Plosives and Sibilance When Recording Vocals

Oct 30
5 min read

Two problems show up on home vocals more than almost anything else: the thump of a "p" that hits the mic like a punch, and the sharp hiss of an "s" that cuts through everything else. They're called plosives and sibilance, and both are much easier to stop at the mic than to fix after the fact. A little setup before you hit record saves you, and your mix engineer, a lot of cleanup later.

Here's how I deal with both when I'm tracking, and what you can do at home with gear you probably already own.

What plosives and sibilance actually are

Plosives happen on consonants like "p" and "b" (and to a lesser degree "t", "d" and "k"). When you say them, a quick burst of air leaves your mouth. If that burst hits the mic capsule directly, it records as a low, boomy thud or a little pop of distortion. It sounds like someone tapped the mic.

Sibilance is the hiss on "s", "sh", "ch", "z" and soft "t" sounds. Some sibilance is natural and you want it, because it's part of how words are understood. The problem is when it's exaggerated, spitty or piercing, so every "s" jumps out of the track and hurts a little on earbuds.

They come from different places, so they need different fixes. Plosives are an air problem. Sibilance is a tone problem.

How to stop plosives when recording vocals

Use a pop filter, and put it in the right place. A mesh or metal pop filter breaks up that burst of air before it reaches the capsule. Set it a few inches in front of the mic, not pressed right up against the grille. The gap matters; it gives the air room to spread out.

Angle the mic slightly off-axis. Instead of singing straight into the center of the mic, turn it a little to the side or tilt it a touch up or down, so the air from your mouth goes past the capsule rather than straight into it. You keep most of the tone and lose most of the thump. Small adjustments do the job here.

Back off a bit. Getting very close to a mic adds low end (that's called the proximity effect) and makes plosives much worse. If you're right on top of the grille, move back a little. You'll usually get a more natural vocal and fewer pops at the same time.

Try the pencil trick. An old studio trick is to tape a pencil vertically down the front of the mic's grille, right across the center. It splits the air stream on hard consonants. It looks odd, but it works, and it costs nothing.

Watch your delivery on the hard lines. If one word keeps popping, don't just sing it softer. Try turning your head slightly on that word or easing up on the consonant without losing the energy of the line. Singers learn to do this without thinking about it after a while.

How to tame sibilance at the source

Check your mic angle and height. Sibilance is very directional. Aiming the mic at your mouth from slightly above, or slightly off to one side, often softens harsh "s" sounds right away without dulling the rest of the voice. Move it, record a line full of "s" words, and listen back.

Pick the right mic for the voice. Some mics have a bright top end that flatters one singer and makes another sound spitty. If you have more than one mic, try them all on the same line. The one that sounds a little less exciting on the "s" sounds is often the one that mixes better.

Don't over-brighten on the way in. If you have EQ in your recording chain, avoid boosting the highs while tracking. You can always add air in the mix. You can't easily take back harshness that's printed into the recording.

Mind your room. Hard, reflective surfaces near the mic can make sibilance sound harsher, because the hiss bounces back into the mic. Soft material behind and around you helps here too. I went into this in How to Set Up a Home Vocal Space on a Budget.

Hydrate. A dry mouth makes clicks and spitty sibilance worse. Keep room-temperature water close and take sips between takes.

Test before the real takes

Before you record the song, record a test phrase that's loaded with the trouble spots. Something like "Peter's purple bike sped past seven sleepy sisters" covers both problems in one breath. Sing it at full performance level, not a polite whisper, because plosives and sibilance get worse when you're giving it everything.

Then listen on closed-back headphones:

  • Hear a low thump or a crackle on the "p" and "b" words? Move the pop filter, angle the mic, or back off.

  • Do the "s" sounds sting or stick out above the rest of the vocal? Change the mic angle or height, or try a different mic.

  • Sound good at a quiet volume but harsh when you turn it up? That's often sibilance that will need some help in the mix, so it's worth fixing more at the mic now.

Once the test sounds clean, mark your position and the mic setup so you can come back to it on the next session.

What gets fixed in the mix (and what doesn't)

Some cleanup is a normal part of mixing. A de-esser can calm down sibilance that's a bit too hot, and a stray plosive or two can be reduced with careful editing and filtering. I do that kind of work on almost every vocal.

But there are limits. A plosive that has overloaded the mic or the preamp has distortion baked into it, and that's hard to remove cleanly. Heavy sibilance that needs aggressive de-essing can leave the singer sounding lispy or dull. The more you fix at the source, the more natural the final vocal will sound, and the more time your engineer can spend making it sound great instead of repairing it.

The bottom line

Plosives are about air: use a pop filter with a little gap, angle the mic off-axis, and don't crowd the grille. Sibilance is about tone: find the right mic angle, height and mic for the voice, and don't brighten it on the way in. Test with a tricky phrase at full volume before you commit to the takes.

When your vocals are tracked and ready, I can take it from there with online mixing. Send me the dry vocal along with the rest of the track, and let me know how you want it to feel.

— Jim

If you'd like one-on-one help with your own mix, vocals or audiobook, you can book an online session with me.

Comments


© 2026 East Coast Recording Company  

215-287-0717  | 780 Falcon Circle Suite 300, Warminster, PA 18974

  • Grey Facebook Icon
bottom of page